Introduction: How To Repair A Laptop With No Picture? I have repaired many laptops with this simple tip. The problem with many laptops is that their heat dispersion is really bad.
Sometimes it gets so hot that even the solder on the graphics control chip melts. If you are wondering how to fix this problem, I want you to read this.
First, I want to show you how to get into your laptop. This can be tricky but it doesn’t have to be. You just need to open the laptop case with a flat head screwdriver.
Now, you should carefully unplug the battery from your laptop. Now, you are ready to see what the problem is. Usually this is because the fan in your laptop is not working properly. There are a couple of things that can cause this but the most common is overheating.
One way to fix this is to remove the battery and put the power cord back in. Now, you need to take off the cooling vents from the inside of your laptop. Now, you should take the screwdriver and slide it under the vent. You are going to have to get underneath the notebook for this to work. If you need more help on this, you can search for “under the laptop” on Google.
After removing the cooling vents, you should put your power cord back in. Now you can try to use the screwdriver to remove any dirt or grease that might be stuck inside. If the screwdriver doesn’t come out with ease, you can try to use a small screwdriver. That’s probably going to work if you are having trouble getting at the inside of your notebook.
Once this is done, you are going to take your laptop apart. There are two methods that I can recommend. You can either buy some type of repair kit, or just repair your laptop yourself.
If you decide to do it yourself, there are a couple of things that you need to fix before you try to fix the laptop. Make sure you take your time and make sure that you have all the tools you need. Some of the tools that you are going to need to include are the screwdriver, the screw, some type of screw driver, a little bit of pliers, and a small flat-head screwdriver.
When you start to repair your laptop, make sure you remove the battery. Now, you should put the battery back in your notebook and plug it in again. Next, you are going to want to replace the cooling vents that are located in the bottom of the notebook. It may be hard to find these, so be patient and check all around until you find one that you can use.
Once you have replaced the cooling vents, you are going to want to use some type of cleaner to clean the inside of your notebook. Make sure that you use a lint-free cloth or paper towels. to keep the inside of your notebook clean and avoid anything from getting on them.
The next step to how to repair a laptop using this method is to put the fan back into your notebook. Now, you are going to want to turn the fan on and let it run a while. Make sure you shut the power off and let it cool down for five minutes before you turn your laptop on again.
Once you have turned the fan off, you are now ready to take your notebook apart again. Once you are done, make sure you put your laptop into its casing once more. If you found a piece of your laptop, you will need to replace the battery.
This is a basic guide to how to repair a laptop using this method. However, it is a very general guide and may not apply to every case.